Washer Code Fix

Home › Notices & modes

Samsung Washer Cb / C6 Code: Calibration Mode Explained

CbC6
Notice - not a fault

Quick answer: Cb or C6 means the washer is in calibration mode, which recalibrates its weight detection (used to set the water amount per cycle). Samsung says this is typically done at the end of installation, so it is a mode and not a fault.

Do not confuseCE means hot and cold hoses swapped (see the hot/cold page). Samsung UK's table has the explanations for Cb and CE mixed up, so rely on this page.

What to check

  1. Make sure the drum is completely empty. Calibration will not be accurate otherwise.
  2. If something is inside, remove it and run calibration again.
  3. Let it run: the drum turns back and forth for 1-3 minutes and then ends by itself.
  4. See your manual or Samsung's installation article for how to start calibration.

How to clear or reset it

It ends by itself after 1-3 minutes.

When to call a technician

Not needed; Samsung treats this as a normal mode.

Frequently asked questions

What does Cb mean on a Samsung washer?

Cb or C6 means the washer is in calibration mode, which recalibrates its weight detection (used to set the water amount per cycle). Samsung says this is typically done at the end of installation, so it is a mode and not a fault.

How do I fix the Cb code?

1. Make sure the drum is completely empty. Calibration will not be accurate otherwise. 2. If something is inside, remove it and run calibration again. 3. Let it run: the drum turns back and forth for 1-3 minutes and then ends by itself. 4. See your manual or Samsung's installation article for how to start calibration. It ends by itself after 1-3 minutes.

Do I need a technician for Cb?

Not needed; Samsung treats this as a normal mode.

Related codes

Sources

Summarised and paraphrased from the sources above; last reviewed 2026-11-19. Your model may differ: always check your own user manual. See the disclaimer.